09/2006
Page 6 of 6 ISCH2200ENC_Rev_0
KNOB
SHIFTING THE CONTROL
To shift the control into forward or reverse, pull the umbrella up
toward the knob and advance the handle forward (for forward
travel) or rearward (for reverse travel) until the handle settles
into a detent at approximately 30
○
of travel (see Figure 8). At
this point, the control has engaged the gear and automatically
entered the throttle mode where further advancement of the
handle will increase the throttle. Once in the throttle mode, it is
no longer necessary to pull on the umbrella. Increase or
decrease throttle by simply moving the handle.
1. PUSH (AND HOLD)
BUTTON IN
2. PULL UMBRELLA UP
3. ADVANCE HANDLE
UMBRELLA
STEM
BUTTON
SHIFTING
FORWARD
SHIFT
POSITION
FIGURE 8
REVERSE
SHIFT
POSITION
NEUTRAL
POSITION
OPERATION OF CONTROL
THROTTLE WARM-UP IN NEUTRAL POSITION
To start the boat's engine and to activate the throttle for engine
warm-up, the handle must be in the neutral position. Neutral
can be found by rotating the handle (by grasping the knob or
stem) until the handle locks in position and can not be rotated
in either direction. Usually the handle is vertical as shown in
Figure 7 when in the neutral position.
FIGURE 7
Push in the button with your left hand while grasping the
umbrella and knob with your right hand and pull the umbrella
up toward the knob (see Figure 7). While still holding the
button and umbrella, advance the handle forward to put the
control in warm-up throttle mode. Once in this mode, the
button and umbrella can be released and throttle can be
adjusted by simply moving the control handle away from the
neutral position to increase throttle and towards the neutral
position to decrease throttle. Returning the handle to the
neutral position will disengage throttle warm-up.
THROTTLE
THROTTLE
30
0
30
0
