Genie_TS_Series GigE Vision Camera
Operational Reference
65
Reduce the value for the exposure knee position
multiSlopeKneePositionY
(start by decreasing
by values of 10)
.
As the exposure knee point is dropped, the saturated image areas will start to
have detail as the effective sensitivity of the bright areas is reduced.
Reduce the value for
multiSlopeKneePositionX,
while grabbing frames to observe the quality of
the image, keeping in mind the effective change as described in the preceding graphics.
Note also that
multiSlopeKneePositionY and multiSlopeKneePositionX
will interact and therefore
change the effective results for a given imaging situation. With variable lighting such as a
camera outdoors, the two multi-slope variables and the camera iris will need dynamic
adjustments to maintain image quality.
I/O Control Category
The Genie TS I/O controls, as shown by CamExpert, groups features used to configure external
inputs and acquisition actions based on those inputs, plus camera output signals to other devices.
Parameters in gray are read only, either always or due to another parameter being disabled.
Parameters in black are user set in CamExpert or programmable via an imaging application.
Features listed in the description table but tagged as
Invisible
are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications. Also important, Genie
TS cameras are available in a number of models implementing different sensors and image
resolutions which may not support the full feature set defined in this category.
