Genie_TS_Series GigE Vision Camera
Operational Reference
99
Cycling Preset Mode Control Feature Description
The following table describes these features along with their view attribute and device framework version. For each feature the device version
may differ for each camera sensor available and whether the camera is programmed with Standard firmware (STD), JPEG firmware (JPG), or
Fast firmware (FST). Such differences will be clearly indicated for any applicable feature.
When a Device Version number is indicated, this represents the camera software functional group, not a firmware revision number. As Genie
TS capabilities evolve the device version will increase, therefore identifying the supported function package. New features for a major device
version release will be indicated by
green text
for easy identification.
The first column indicates whether a feature applies to monochrome or color camera models via a symbol. No symbol indicates a common
feature. Additionally the description column will indicate which feature is a member of the DALSA Features Naming Convention (denoted by
DFNC), versus the GenICam Standard Features Naming Convention (SFNC not shown).
B/W
Color
Display Name
Feature & Values
Description
Vouvray
DALSA
CMOSIS
CMX xx
AnaFocus
Lince 5M
cyclingPresetMode
Sets
the
Cycling Presets module mode.
< Expert, DFNC >
V1.10
All Designs
V1.10
All Designs
V1.20
Fast
Off
Off Disable the Cycling Preset module.
Active
Active Enable the Cycling Preset module.
Cycling Preset Count cyclingPresetCount
Specifies
the number of Presets to use.
< Expert, DFNC >
all all Fast
Cycling
Preset Incremental
Source
cyclingPresetIncrementalSource
Specifies the source that increments the currently active
cycling preset.
< Expert, DFNC >
all all Fast
None
None
Feature
cyclingPresetCurrentActiveSet is used to select
the current active set.
Valid Frame Trigger
ValidFrameTrigger Increment on a Valid Frame Trigger
Counter 1 End
Counter1End Increment on the end of Counter 1.
Start of Frame
StartOfFrame Increment on the Start of Frame event
Cycling Preset Repeater
cyclingPresetRepeater
Specifies the required number of cycling preset increment
events (generated by the Cycling Preset Incremental
Source) to increment the index of the Cycling Preset
Current Active Set.
< Expert, DFNC >
all all Fast
Cycling Preset Reset Source
cyclingPresetResetSource
Specifies the source that resets the currently active
preset. On reset the current preset index is set to 1.
< Expert, DFNC >
all all Fast
Valid Frame Trigger
ValidFrameTrigger Reset when a Valid Frame Triggers occurs.
Counter 1 End
Counter1End Reset when counter 1 ends.
Acquisition End
EndOfAcquisition Use End of Acquisition as the reset source. An End of
Acquisition occurs on acquisition stop.
