Teledyne T300, Operation Manual, Page: 104 / 426

Setup Menu Teledyne API – Model T300/T300M CO Analyzer
102
5.4.3.1. SINGLE RANGE MODE (SNGL)
Single Range Mode (SNGL) is the default reporting range mode for the analyzer.
When the single range mode is selected ( SNGL ), all analog CO concentration outputs
( A1 and A2 ) are slaved together and set to the same reporting range limits (e.g. 500.0
ppb). The span limit of this reporting range can be set to any value within the physical
range of the analyzer.
Although both outputs share the same concentration reporting range, the electronic
signal ranges of the analog outputs may still be configured for different values (e.g. 0-5
VDC, 0-10 VDC, etc; see Section 5.9.3.1)
To select SNGL range mode and to set the upper limit of the range, press:
SAMPLE RANGE=50.00 PPB CO=XX.XX
<TST TST> CAL SETUP
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X RANGE MODE MENU
MODE SET UNIT DIL EXIT
SETUP X.X RANGE MODE:SNGL
SNGL DUAL AUTO ENTR EXIT
SETUP X.X RANGE MODE:SNGL
SNGL DUAL AUTO ENTR EXIT
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT DIL EXIT
SETUP X.X RANGE:500.0 Conc
0 0 5 0 0 .0 ENTR EXIT Toggle these keys
to select the upper
SPAN limit for the
shared CO
reporting range.
EXIT discards the new
setting.
ENTR accepts the
new setting.
SETUP X.X O2 RANGE:100.00 %
1 0 0 .0 0 ENTR EXIT
Toggle these keys to select the
upper SPAN limit for the CO
2
or
O
2
reporting range
NOTE
Only appears if the optional CO
2
or
O
2
Sensor is installed.
06864B DCN6314