Teledyne T200, Operation Manual, Page: 109 / 425

Teledyne API
– T200 NO/NO
2
/NO
X
Analyzer Operation Manual Setup Mode Menus
107
5.9.3.1. ANALOG OUTPUT VOLTAGE / CURRENT RANGE SELECTION
In its standard configuration the analog outputs is set to output a 0 – 5 VDC signals.
Several other output ranges are available (see Table 5-6). Each range is usable from -
5% to +5% of the rated span.
Table 5-6: Analog Output Voltage Range Min/Max
RANGE NAME RANGE SPAN MINIMUM OUTPUT MAXIMUM OUTPUT
0.1V
0-100 mVDC -5 mVDC 105 mVDC
1V
0-1 VDC -0.05 VDC 1.05 VDC
5V
0-5 VDC -0.25 VDC 5.25 VDC
10V
0-10 VDC -0.5 VDC 10.5 VDC
The default offset for all VDC ranges is 0-5 VDC.
CURR
0-20 mA 0 mA 20 mA
While these are the physical limits of the current loop modules, typical applications use 2-20 mA or 4-20 mA for the lower and upper
limits. Please specify desired range when ordering this option.
The default offset for all current ranges is 0 mA.
To change the output type and range, select the ANALOG I/O CONFIGURATION
submenu (see Figure 5-5) then press:
DIAG AIO AOUTS CALIBRATED: NO
SET>
CAL EXIT
From the
AIO CONFIGURATION SUBMENU
DIAG
ANALOG I/O CONFIGURATION
PREV NEXT
ENTR
EXIT
Continue pressing
SET>
until you reach the
output to be configured
DIAG AIO CONC_OUT_2: 5V, OVR, NOCAL
<SET SET>
EDIT
EXIT
DIAG AIO CONC_OUT_2: RANGE: 5V
0.1V 1V 5V 10V CURR ENTR EXIT
These buttons
set the signal
level and type
of the selected
channel.
Pressing
ENTR
records
the new setting and
returns to the previous
menu.
Pressing
EXIT
ignores the
new setting and returns to
the previous menu.
DIAG AIO CONC_OUT_2 RANGE: 5V
<SET SET>
EDIT
EXIT
06858E DCN7057