Teledyne Sierra M6-2, User Manual, Page: 252 / 538

Teledyne LeCroy Analysis
250 Sierra M6 ‐ 2 SAS/SATA Protocol Analyzer User Manual

Status: All, Custom, Incomplete, Normal Output

Timeout: such as All, Custom, N/A, Yes and No (see “Time out of ATA Command
Report” on page 250 )

Duration : All, Custom, or time unit

Count : All, Custom, or a number of occurrences

% : of total count
Figure 3.42: SATA: ATA Command Report
Time out of ATA Command Report
The Time out shows the NCQ time out. It is applicable for only NCQ commands. A
threshold can be set in the "NCQ commands Timeout Threshold", the default value is
1000

sec (the user can change it to any value). The statistical report provides a "Time
out" report based on this threshold. Any NCQ command that takes more than the given
threshold is flagged as "yes", which means that a timeout occurred for that command.
ATAPI Report
To display the ATAPI Report, click the ATAPI tab. The ATAPI Report displays information in
the following columns (see the following screen capture):

Command : All, Custom, Inquiry, Mode Sense 10, Read10, Request Sense

Direction : All, H ‐ >D, D ‐ >H, or Custom

Number of FIS or Number of Transport : All, Custom, or a number

Payload Size : All, Custom, or a number of DWORDs

Status : All, Custom, Check Condition, Good

Duration : All, Custom, or time unit (accumulative)

Count : All, Custom, or a number of occurrences

%: of total count
Figure 3.43: SATA: ATAPI Report