Teledyne ProEM Series, System Manual

Page: 23 / 162

Chapter 2 ProEM Camera System 23
2.2.5.1 Coolant Ports
QDC (Low Profile) Male Shutoff Nozzles (Koolance, part number VL2-MG). Located on
the side of the camera, these are interchangeable quick-disconnect inlet/outlet ports.
ProEM-compatible female barbs (part number VL2-F10B-P) are available from Koolance
(
www.koolance.com
).
2.3 Coolant Circulator
ProEM cameras can be optionally cooled by circulating coolant to provide a low
vibration system for data acquisition. They are equipped with two ports with
quick-disconnect fittings for connection to an external circulator. Two 10 mm
[3/8 inch] ID, 3 meter [10 foot] coolant hoses with ProEM-compatible fittings are
provided with each ProEM system.
The coolant circulator can be any commercially available circulator that is capable of
continuously pumping a 50:50 mixture of room temperature (23°C) water and ethylene
glycol at 1 liter per minute, or the Teledyne Princeton Instruments CoolCUBE
II
. Contact
the factory for recommendations. Refer to Contact Information on page 160 for
complete information.
2.4 Cables
Table 2-2 describes the cables included with a standard ProEM Camera System.
LOGIC OUT 0 to +3.3V programmable logic level output (TTL-compatible). The output of
this connector can be programmed and can also be inverted via the application
software. Refer to
Section 6.3, LOGIC OUT Control , on page 97 for complete
information about each LOGIC OUT signal.
Table 2-1: ProEM Connectors and Indicators (Sheet 2 of 2)
Connector Description
Table 2-2: Standard ProEM Camera System Cables (Sheet 1 of 2)
Cable
Part
Number
Description/Purpose Length
Ethernet
Cable
6050-0621 This standard cable is a Cat 5e/6 Ethernet cable
for connecting the camera and the host
computer. The distance between the camera and
the computer can be over 50 meters. Contact the
factory for longer cables. 5 m
[16.4 ft]
4
4
11-
012
6
_0
105