Teledyne ProEM Series, System Manual

Page: 15 / 162

Chapter 1 About this Manual 15
1.6 Precautions
To prevent permanently damaging the ProEM system, observe the following
precautions at all times.
CAUTION!
!
1. The CCD array is very sensitive to static electricity.
Touching the CCD can destroy it. Operations requiring
contact with the device can only be performed at the
factory.
2. When using high-voltage equipment (e.g., an arc lamp,)
with the camera system, be sure to turn the camera power
ON LAST and turn the camera power OFF FIRST.
3. When turning off and on the power supply, wait at least 10
seconds before switching it on. The TEC Fault LED might
come on if the power supply on/off state is switched too
quickly.
4. Use caution when triggering high-current switching
devices near the system (e.g., an arc lamp.) The CCD can
be permanently damaged by transient voltage spikes. If
electrically noisy devices are present, an isolated,
conditioned power line or dedicated isolation transformer
is highly recommended.
5. Do not block air vents on the camera. Preventing the free
flow of air overheats the camera and may damage it.
6. If the ProEM camera system is used in a manner not
specified by Teledyne Princeton Instruments, the
protection provided by the equipment may be impaired.
1.6.1 UV Coatings
CAUTION!
!
If using a camera with a UV (Lumogen or Unichrome™)
coated CCD, protect it from unnecessary exposure to UV
radiation. This radiation slowly bleaches the coating,
reducing sensitivity.
1
1. Footnote text