Teledyne ProEM Series, System Manual

Page: 132 / 162

132 ProEM System Manual Issue 3
Figure 8-8: Typical eBUS Driver Installation Tool Dialog
4. After making the selection, click on Install.
5. After the installation you will be asked to reboot the computer. You can:
• Click on "Yes" to initiate the reboot.
• Click on "No" to wait before rebooting. If you select "No," you may be required
to close the eBUS Driver Installation Tool dialog. Reboot the computer at your
convenience.
6. After the reboot, verify that the network connection has been re-established.
8.12 Program Error Message
The dialog illustrated in Figure 8-9 may appear if you have tried to acquire a test image,
acquire data, or run in focusing mode and the DMA buffer size is too small. A large array
(for example, a 2048 x 2048 array,) requires a larger setting than that for a smaller array
(for example, a 512 x 512 array.)
Figure 8-9: Typical WinX/32 Program Error Dialog
To correct the problem:
1. Click on OK.
2. Reboot WinView/32.
3. Note the array size (on the Setup
►
Hardware
►
Controller/CCD tab or the
Acquisition
►
Experiment Setup
►
Main tab Full Chip dimensions.) If your camera
contains a large array (such as a 2048 x 2048 array), and the DMA buffer size is too
small, there will not be enough space in memory for the data set.
4. Open Setup
►
Environment
►
Environment dialog.
5. Increase the DMA buffer size to a minimum of 32 MB (64 MB if it is currently 32 MB,
or 128 MB if it is currently 64 MB,) click on OK, and close WinView/32.
6. Reboot your computer.
7. Restart WinView/32 and begin acquiring data or focusing. If you see the message
again, increase the DMA buffer size.
4
4
11
-01
26
_
0086
441
1-
0
12
6
_
0
0
8
7