Teledyne Princeton Instruments PICam 5.x, Programmer'S Manual

Page: 336 / 357

334 PICam™ 5.x Programmer’s Manual Issue 11
E.6 PI-MTE: 1300R Cameras
This section provides information necessary to update customer-modified code (PICam
4.x and older) for the following cameras in order for it to work as designed with PICam
5.0:
• PI-MTE: 1300R.
E.6.1 What Changed with PICam 5.0?
In PICam 5.0, the following Low Noise (
PicamAdcQuality_LowNoise
) parameters
have been swapped:
•
PicamParameter_ActiveLeftMargin
and
PicamParameter_ActiveRightMargin
By default, these two parameters remain symmetric, so programs will break only when
one, or both, of these parameters have been set asymmetrically in Low Noise.
E.6.2 Code Updates to Retain Existing Behavior
Table E-6 lists code changes required to PICam 4.x (and older) code in order to
continue working properly with PICam 5.0.
Table E-6: PICam 4.x (and Older) Code Changes: PI-MTE: 1300R
In PICam 4.x and Older Code, if you: … in PICam 5.0, you need to:
Action Parameter Action Parameter
ADC Quality: Low Noise
Get PicamParameter_ActiveLeftMargin Get PicamParameter_ActiveRightMargin
Set PicamParameter_ActiveLeftMargin Set PicamParameter_ActiveRightMargin
Get PicamParameter_ActiveRightMargin Get PicamParameter_ActiveLeftMargin
Set PicamParameter_ActiveRightMargin Set PicamParameter_ActiveLeftMargin