Teledyne Princeton Instruments PI-MTE, System Manual

Page: 87 / 118

Chapter 7 Troubleshooting 87
7.13 Secure the Detector-Controller Cable Slide Latch
Some Teledyne Princeton Instruments Detector-Controller cables use a slide latch to
secure the Detector-Controller cable to the DETECTOR connector on the back of the
ST-133. Incorrectly plugging this cable into the connector and improperly securing the
slide latch may prevent communication with the PI-MTE (the camera may appear to
stop working).
Perform the following procedure to connect and secure the Detector-Controller cable:
1. Before attempting to plug in the cable, slide the latch up toward Pin 1 as illustrated
in Figure 7-13 ).
Figure 7-13: Connector View of Unlatched Detector Connector with Pin 1
2. Plug the cable into the DETECTOR connector on the ST-133.
Figure 7-14: Typical Unlatched Detector Connector
4
4
11-
009
7_
004
8
P
IN
1
U
NLATCHED
4
4
11
-009
7_
004
9
F
ULLY
S
LIDE
L
ATCH
U
P
(UNLATCHED P
OSITION
)