Teledyne Princeton Instruments PI-MTE, System Manual

Page: 37 / 118

Chapter 4 System Setup 37
5. The Welcome dialog similar to that illustrated in Figure 4-3 is displayed.
Figure 4-3: Camera Detection Wizard - Welcome Dialog
Verify I will configure the camera system manually is unchecked. If necessary,
deselect it.
6. Click Next.
7. Follow on-screen prompts to perform the initial hardware setup.
This wizard configures default parameters on the Hardware Setup dialog and
provides the opportunity to acquire a test image to confirm the system is working.
NOTE:
Note that this is only a test image and it is not acquired
using the settings needed for true data acquisition.
For a step-by-step procedure about basic system operation,
refer to
Section 5.2, First Light , on page 41.
4.11 Make the Coolant Connections
CAUTION!
!
1. Take care that the coolant used is pH neutral. Acidic or
alkaline coolant can damage the camera fittings and
internal cooling block through corrosion. Such damage
could be very expensive to repair.
2. Coolant should be no colder than +10° C to +15°C to
prevent condensation at 50% relative humidity. Operating
the camera with coolant at a colder temperature could
cause induced condensation in the electronics enclosure
and possible catastrophic damage to the camera when the
camera is operating outside of a vacuum enclosure.
Damage resulting from this type of operation may void the
warranty.
4
4
11-
009
7_
001
7