Page 24 of 42
10.6.
SETTING LIMIT ALARMS
From
SETUP/CAL
Menu
10.6.1.
Setting a Single Channel’s High Limit
After selecting a channel in the
SETUP/CAL
menu, choose
ALARMS
by pressing the number
5
key
followed by the
ENTER
key. The
ALARMS
menu will be displayed. Pressing the number “
1
” key
selects the
HIGH LIMIT
display. Using the number keys, enter the desired high limit level and then
press
ENTER
.
EXIT
the loop by pressing the number “
4
” +
ENTER
key while the
ALARMS
menu is
displayed.
10.6.2.
Setting a Single Channel’s Low Limit
After selecting a channel in the
SETUP/CAL
menu, choose
ALARMS
by pressing the number
5
key.
The
ALARMS
menu will be displayed. Pressing the number
2
key selects the
LOW LIMIT
display.
Using the number keys, enter the desired high limit level and then press
ENTER
.
EXIT
the loop by
pressing the number
4
key while the
ALARMS
menu is displayed, followed by
ENTER
.
10.6.3.
Setting a Single Channel’s Hysteresis
After selecting a channel in the SETUP/CAL menu, choose ALARMS by pressing the number 5 key. The
ALARMS menu will be displayed. Pressing the number 3 key selects the HYSTERESIS display. Using
the number keys, enter the desired degree of Hysteresis followed by the ENTER key. EXIT the loop by
pressing the number 4 key while the ALARMS menu is displayed, followed by ENTER.
Each channel of the
POWER
POD
-
400
has one high limit alarm and
one low limit alarm. Each alarm is
provided by an open-collector,
opto-isolated signal at a
corresponding pin on the rear
panel, connector J8. Use the
provided diagram when referring
to the text below.
