Teledyne PIXIS-XF, System Manual

Page: 73 / 116

Chapter 6 Advanced Topics 73
6.5.1.1 Software Settings
CAUTION!
!
Teledyne Princeton Instruments does not encourage users
to change these parameter settings. For most applications,
the default settings will give the best results. We strongly
advise contacting the factory for guidance before
customizing the chip definition.
In WinX/32, if Custom Chip has been installed, selecting Show Custom Chip check box
on the Controller/Camera tab adds the Custom Chip tab to the Hardware Setup dialog.
The Custom Chip parameters are shown in
Figure 6-19 . The default values conform to
the physical layout of the CCD array and are optimum for most measurements.
Figure 6-19: Typical WinX/32 Hardware Setup Dialog: Custom Chip Tab
In LightField, the Custom Sensor pane, which is illustrated in Figure 6-20 , is accessed by
opening the Sensor expander and clicking on the Custom Sensor button.
4
4
11
-01
12_0
04
3