Teledyne PIXIS-XF, System Manual

Page: 34 / 116

34 PIXIS-XF System Manual Issue 5
4. Follow the instructions on the dialogs to perform the initial hardware setup: this
wizard enters default parameters on the Hardware Setup dialog tabs and gives you
an opportunity to acquire a test image to confirm the system is working.
NOTE:
For step-by-step instructions about basic system operation,
refer to
Section 5.2, WinX/32 First Light , on page 39.
4.6.2 Configure Default LightField Parameters
1. Verify the PIXIS-XF is connected to the host computer and that the camera power
supply is turned on.
2. Start LightField.
3. While LightField is starting up, it will detect the available device(s) and load the
appropriate icons into the Available Devices area in the Experiment workspace.
4. When you drag an icon into the Experiment Devices area, the appropriate
expanders will be loaded into the Experiment Settings stack on the left-hand side of
the window. See
Figure 4-5 .
Figure 4-5: Typical LightField Experiment Workspace
5. Because this is a new experiment, the default settings will automatically be entered
for the experiment device(s). These settings will allow you to begin previewing (Run
button) or acquiring (Acquire button) data.
NOTE:
For step-by-step instructions about basic system operation,
refer to
Section 5.3, LightField First Light , on page 42.
4
4
11
-0
112
_0015