Teledyne PIXIS-XF, System Manual

Page: 31 / 116

Chapter 4 System Setup 31
The required INF, DLL, and USB driver files will be placed in the appropriate
Windows
directories. Refer to Table 4-1 .
2. Make sure the camera is connected to the host computer and that the camera
power supply is turned on.
3. Reboot the computer.
4. At boot up, Windows will detect the Teledyne Princeton Instruments USB2 Interface
hardware in the PIXIS-XF.
4.4.2 Install LightField
The following installation is performed via the LightField software installation CD.
1. Before starting the installation:
• Verify that the computer operating system is Windows Vista (64-bit) or
Windows 7 (64-bit).
• Confirm that your computer supports USB 2.0. If it does not, please refer to the
manufacturer's instructions for installing a USB 2.0 interface card.
• Verify that your computer is connected to the Internet. Internet connection is
required for product activation.
2. Insert the CD and follow the installation wizard prompts.
Figure 4-2: Typical LightField Installation Wizard Dialog
Table 4-1: USB Driver Files and Locations
Windows
Version
INF File,
Located in
"Windows"/INF
a
a. The INF directory may be hidden.
Properties DLL,
Located in
"Windows"/System32
Device Driver,
Located in
"Windows"/System32/
Windows XP
Vista (32-bit)
rsusb2k.inf apausbprop.dll apausb.sys
4
4
11
-0
112_
0012