Teledyne PIXIS-XF, System Manual

Page: 30 / 116

30 PIXIS-XF System Manual Issue 5
4.4 Install the Application Software
This section provides information about installing image acquisition software.
4.4.1 Install WinX/32
NOTES:
1. Before proceeding, determine if the host computer
supports USB 2.0. If it does not, install a USB 2.0
interface card. Follow the manufacturer's instructions.
2. Leave the USB cable disconnected from the camera
until you have installed WinView/32 or WinSpec/32.
The following installation is performed via the WinView/32 or WinSpec/32software
installation CD.
1. On the Select Installation Type dialog illustrated in
Figure 4-1 , select:
• Typical to install the required drivers and the most commonly installed program
files;
• Custom to select among the available program files or do not want to install the
drivers;
• Complete to install all application features.
Figure 4-1: Typical WinView Installation Dialog: Select Installation Type
4
4
11
-0
112_
0011