Teledyne PIXIS-XF, System Manual

Page: 18 / 116

18 PIXIS-XF System Manual Issue 5
2.1.1 PIXIS-XF Rear-Panel Connectors and Indicators
Figure 2-3 illustrates the rear-panel connectors and indicators on a PIXIS-XF camera.
Figure 2-3:
PIXIS-XF
Rear-Panel Connectors
Refer to Table 2-1 for information about each rear-panel connector and indicator.
Table 2-1: PIXIS-XF Rear-Panel Connectors and Indicators
Label Description
EXT SYNC
0 to +3.3-5V
DC
logic level input (TTL-compatible) that has a 10 k

pull-up
resistor. Allows data acquisition and readout to be synchronized with external
events. Through software, positive or negative (default) edge triggering can be
selected.
LOGIC OUT 0 to +3.3V
DC
programmable logic level output (TTL-compatible). The output of
this connector can be programmed and also inverted via the application
software. For additional information, refer to
Section 6.3, LOGIC OUT Control ,
on page 67.
USB 2.0 Control signals and data are transmitted between the camera and the host
computer via the USB port located on the rear of the camera. You can hot plug
the PIXIS-XF camera whenever the WinX application is not running (i.e., connect
or disconnect from the camera or the host computer while the camera is on).
POWER 12 V
DC
(6.6A max) input from power supply.
SHUTTER
LEMO
®
connector provides the shutter drive pulses for driving an optional
Teledyne Princeton Instruments-supplied 25 mm external slit shutter. Camera
power must be off before connecting to or disconnecting from this connector.
4
4
11-
011
2
_000
3