Teledyne Kibra DDR, User Manual, Page: 65 / 174

Kibra DDR Protocol Analyzer User Manual 63
Recording Options Setup Teledyne LeCroy
Sequence Trigger
Sequence triggers can be set to be performed on signals. The options are:

Arm on

Signals ‐ Click the link to open the DDR Select Signals dialog (see Figure 2.34
on page 65 .)

No Arm

Trigger on

Signals ‐ Click the link to open the DDR Select Signals dialog (see Figure 2.34
on page 65 .)

Trigger After ‐ specified (nck)

Reset Arm

Never

Signals ‐ Click the link to open the DDR Select Signals dialog (see Figure 2.34
on page 65 .)

After ‐ specified (nck)
Figure 2.32: Sequence Trigger Settings
Note:
Hold mouse over fields to display tooltips.
The Sequence Trigger feature provides a powerful triggering engine which allows for
defining the trigger at the signal level with arm and roll ‐ back condition. You can define
the following trigger conditions:

Trigger on any signal transition

Trigger on combination of signals that make a specific command

Trigger on sequence of conditions

Some custom violation detection sequences
The advance trigger has three major conditions:

Arm condition : This condition is used to define condition before trigger.

Reset ‐ Arm condition : This condition causes resetting of the Arm condition.