PS200
PORTABLE GAS MONITOR
4
64171
The Company takes no responsibility for use of its equipment if it is not used in accordance with
these instructions. If further operational or maintenance details are required but not provided in this
guide, contact the Company or their agent. The Company shall not be liable for any incidental or
consequential damages in connection with any modifications, errors or omissions in this guide.
Always observe the latest pertinent state, regional, and local safety regulations when using and
disposing of the monitor. For reasons of safety and to assure regulatory compliance, only the
manufacturer should perform repairs.
Fully trained personnel must regularly service and calibrate the monitor in a safe area.
Only use replacement parts approved by the Company.
Re-charge the monitor only in a safe area (refer to
Section 7. Recharging the Batteries
).
If the monitor detects gas, follow your organization’s procedures and operational guidelines.
Any right of claim relating to product liability or consequential damage to any third party against
the Company is removed if the above warnings are not observed.
1.4. Additional Safety Details - CSA ONLY
Caution: Before each days usage, test on a known concentration of
methane, equivalent to 25% – 50% of full-scale concentration.
accuracy must be within 0 to +20% of actual. Accuracy may be
corrected by calibration (refer to
Mise en garde: avant chaque utilisation journalière, testez la réaction
de l’appareil en utilisant une concentration connue en méthane,
correspondant à 25% – 50% de la valeur réelle. la précision doit se
situer entre 0 et + 20% de la valeur réelle. la précision peut se corriger
en étalonnant l’appareil (voir
).
Caution: Any rapid up-scale readings followed by a declining or
erratic reading may indicate a gas concentration beyond the upper
scale limit, which may be hazardous.
Mise en garde: Out lecture dèpassant rapidement le maximum de
l’êchelle et suivie par une diminution ou une lecture erronée, indique
une concetration de gaz supérieure à la valeur maximale de cette
échelle. Cette lecture n’est passignificative.
Caution: Substitution of components may impair intrinsic safety.
Revision 12
.1