Teledyne Genie Monochrome Series M1280, User Manual

Page: 123 / 279

Nano Series GigE Vision Camera Operational Reference
•
121
Counter and Timer Control Category
The Genie Nano counter and timer controls, as shown by CamExpert, has parameters used to
configure acquisition counters and timers for various input lines and signal edge detection.
Parameters in gray are read only, either always or due to another parameter being disabled.
Parameters in black are user set in CamExpert or programmable via an imaging application.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications. Also important, Genie
Nano cameras are available in a number of models implementing different sensors and image
resolutions which may not support the full feature set defined in this category.
Counter and Timer Control Feature Description
The following table and block diagram , describes these parameters along with their view attribute
and minimum camera firmware version required. Additionally the Device Version column will
indicate which parameter is a member of the DALSA Features Naming Convention (indicated by
DFNC), versus the GenICam Standard Features Naming Convention (SFNC tag is not shown).
The Device Version number represents the camera software functional group, not a firmware
revision number. As Genie Nano capabilities evolve the device version tag will increase, therefore
identifying the supported function package. New features for a major device version release will be
indicated by green text for easy identification.