Teledyne Foxy R1, Instruction Manual

Page: 20 / 102

Foxy
®
R1 and Foxy
®
R2 Fraction Collectors
Section 1 Introduction
1-8
1.5 Rear Panel Connectors
The rear panel connectors are used to power the fraction collector
and connect it to other devices.
Table 1-3 Rear Panel Connectors
Connectors Item Number Description
1 Ethernet 1 Connector (See Table 1-4)
2 Ethernet 2 Connector (Table 1-4)
3 Pump Connector (Table 1-5)
4 Detector Connector (Table 1-6)
5 RS-232 Serial Connector (Table 1-7)
6 AC Mains Power
Mains power must meet the voltage, fre-
quency, and amperage requirements
listed on the serial number label. Mains
power fluctuations must not exceed 10%
of the nominal supply voltage.
The mains power cord is the disconnect
device.
Table 1-4 Ethernet Connector Pins
Connector Pin Type Description
1 Output/Input TX+ / RX+ (auto MDI/MDIX)
2 Output/Input TX– / RX– (auto MDI/MDIX)
3 Input/Output RX+ / TX+ (auto MDI/MDIX)
4 Termination
5 Termination
6 Input/Output RX– / TX– (auto MDI/MDIX)
7 Termination
8 Termination