Teledyne 200A, Instruction Manual, Page: 46 / 220

Teledyne API Model 200A NO
X
Analyzer Instruction Manual, 02246, Rev. F1
Table 5-3: M200A Menu Structure - Setup Menu #2
Setup Menu #2
Level 1 Level 2 Level 3 Level 4 Description
Reference
Section
RANGE Range control menu 5.3.4
MODE Range mode select – Single,
Autorange, Independent 5.3.4
SET Sets range if mode is Single
range 5.3.4.1
NO Sets NO concentration if indep
ranges enabled 5.3.4.3
NO
x
Sets
NO
x
concentration if indep
ranges enabled
5.3.4.3
NO
2
Sets NO
2
concentration if indep
ranges enabled
5.3.4.3
LO Sets low range if Autorange
enabled 5.3.4.2
HI Sets high range if Autorange
enabled 5.3.4.2
UNITS Unit selection menu 5.3.4.5
PPB,PPM,
UGM,
MGM
Select units that instrument uses 5.3.4.5
DIL Enter dilution factor if
connected to stack dilution
probe 5.3.4.4
PASS Password enable/disable menu 5.3.5
ON-OFF Enable/disable password
checking
5.3.5
CLOCK TIME Adjusts time on the internal
time of day clock 5.3.6
DATE Adjusts date on the internal
time of day clock 5.3.6
MORE Continue menus on next level
down Table 5-2
COMM RS-232 communications
control menu
5.3.8, 5.5
BAUD Sets the BAUD rate to 300 -
19,200 5.3.8, 5.5
ID Sets the instrument ID -
(included on all RS-232
messages) 5.3.8, 5.5
Table 5-4: M200A Menu Structure - Setup Menu #3
5-6