MDA800A Getting Started Guide
49
CANADIAN CERTIFICATION
The has been certified by Underwriters Laboratories (UL) to conform to
the following safety standard and bears the cUL Listing Mark:
CAN/CSA-C22.2 No. 61010-1-12. Safety requirements for electrical
equipment for measurement, control and laboratory use.
Environmental Compliance
END-OF-LIFE HANDLING
The instrument is marked with this symbol to indicate that it complies
with the applicable European Union requirements to Directives
2012/19/EU and 2013/56/EU on Waste Electrical and Electronic
Equipment (WEEE) and Batteries.
The instrument is subject to disposal and recycling regulations
that vary by country and region. Many countries prohibit the
disposal of waste electronic equipment in standard waste receptacles. For
more information about proper disposal and recycling of your Teledyne
LeCroy product, please visit teledynelecroy.com/recycle.
RESTRICTION OF HAZARDOUS SUBSTANCES (RoHS)
MDA800A and its accessories conform to the 2011/65/EU RoHS2 Directive.
ISO Certification
Manufactured under an ISO 9000 Registered Quality Management System.
Intellectual Property
All patents pertaining to the MDA800A can be found on our website at:
teledynelecroy.com/patents/
Safety Compliance
EC DECLARATION OF CONFORMITY – LOW VOLTAGE
The instrument meets intent of EC Directive 2014/35/EU for Product
Safety. Compliance was demonstrated to the following specifications as
listed in the Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment
for measurement, control, and laboratory use – Part 2-030: Particular
requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the
following limits put forth by these standards:
•
Mains Supply Connector: Overvoltage Category II, instrument intended
to be supplied from the building wiring at utilization points (socket
outlets and similar).
•
Measuring Circuit Terminals: No rated measurement category.
Terminals not intended to be connected directly to the mains supply.
•
Unit: Pollution Degree 2, operating environment where normally only
dry, non-conductive pollution occurs. Temporary conductivity caused
by condensation should be expected.
U.S. NATIONALLY RECOGNIZED AGENCY CERTIFICATION
The has been certified by Underwriters Laboratories (UL) to conform to
the following safety standard and bears the UL Listing Mark:
UL 61010-1 Third Edition – Safety standard for electrical measuring and
test equipment.
REFERENCE