4 Service
BCS II Simplex Repeater User Manual
4-2
Telect, Inc.
117209-1 A0
4.
When the LED snaps into place, the installation is complete.
5.
To test the new LED, insert a plug into the “M” (monitor) jack.
The LED flashes for about 30 seconds, then lights steadily.
I
N
C
ASE
O
F
D
IFFICULTY
If problems occur after initial installation, check all cable connections
and the installation instructions in Chapter 2.
Technical Support
By e-mail: [email protected]
By phone: 888-821-4856 or 509-921-6161
I
N
-W
ARRANTY
S
ERVICE
Contact your Telect equipment distributor, or call a Telect Customer
Service Representative:
1-800-551-4567
1-509-926-6000
Telect will repair or replace defective products within the limits of the
warranty. See “Repacking for Shipment” in this section.
NOTE
Call a Customer Service Representative for a Return Material Authori-
zation (RMA) before returning any equipment.
Flat surface of LED to
flat surface of socket
Leads
LED
Summary of Contents for BCS II
