31
www.behnke-online.com
Configuration and Set-up
GB
Additional SIP door bell / SIP PA system connection
▸
Connection via SIP intercom station with 10/100
Mbit Ethernet LAN
▸
Power supply via Power over Ethernet (PoE
according to IEEE 802.3af)
By default, Behnke SIP electronics come pre-set
to automatic IP configuration via DHCP. It will
automatically obtain its IP address from a DHCP
server, where available. Otherwise, cf. page 29
or 39.
2.
configurAtion And set-up
2.1. Preparation
2.1.1. 20-0040-IP
RJ45 connection socket (LAN) (from the switch,
POE class 0 power supply)
Level adjustment for PA system connection
(adjustable with 0.4x2 slotted screwdriver)
speakON socket for connection to PA system
(LF audio output) and for contacting the relay
(potential-free normally open contact)
Wall mounting holes (mounting material (dowels/
screws) included in the box)
Compatible plug (included in the box):
Neutrik speakON NL4FX / NL4FC
Please see the open plug for the plug assignment
(cover cap removed through strain relief)
Caution: For wiring, cf. page 36 of this manual or
the label next to the plug on the housing
After the power supply has been established, it
takes about 90 seconds for the door intercom
station to automatically start to announce its IP
address. Once you have heard this signal, your
intercom station is available.
Caution:
When you connect your SIP door intercom
station to a new network, it may take up to 5 min-
utes before the device will obtain a new IP address
from the DHCP server.
1-
1+
2+
2-
