Installation instructions
│
T24
│
Chapter 9: Configuration menu
9.5 Erase a transmitter f rom a receiver
This procedure erases the transmitter from the receiver and vice versa.
NOTE: The receiver must be powered up for the Erase procedure to be successful.
1. Make sure that the
Stop
button is pressed.
2. Twist and release the
Stop
button.
The initial start-up logo is displayed.
Battery indicator(s) light(s).
The
display shows:
[PUSH START BUTTONS]
.
3. Enter
Menu mode
(see
"9.2 Enter Menu mode (no PIN code required) "
)..
4. Navigate to the
[Erase]
menu using the
Up/Down
buttons.
5. Press the
Select
button to enter.
6. Choose the receiver(s) to be erased from using the
Up/Down
buttons.
7. Press the
Select
button to select.
A + sign is displayed in front of the selected item(s).
8. Press the
Back
button to accept.
The display shows:
[Erase in progress…]
l
If successfully completed:
The display shows:
[Erase successful]
. The transmitter turns off.
l
If not successfully completed:
The display shows:
[Erase failed. Timout]
. The transmitter turns off.
Go back to step 1 and try again.
IM-PM-TX101-EN-v08
55
