6.5 Log the transmitter ou t f rom a receiver
IMPORTANT! For the logout function to work, BOTH the receiver and the
transmitter must have the logout function activated and be set to continuous
radio mode.
A transmitter already logged in to the receiver has to be logged out before any
other transmitter can be logged in. If a transmitter has been lost or seriously
damaged, use the replace procedure on the transmitter.
NOTE: Logout can only be performed when the transmitter is on and a radio link
with one or more receivers has been established. The receiver must be powered-
up for the logout procedure to be successful.
NOTE: The logout procedure will log the transmitter out from all receivers that
are part of the radio session.
NOTE: The logout function cannot be activated/deactivated from the transmitter
Contact your representative for assistance.
For this transmitter, the logout function is activated by default.
1
6.5 .1 Q UI C K L O G O UT
1. Make sure that the transmitter is started. If not, twist and release the
Stop
button.
2. Press and hold button 7.
3. Press the
Stop
button.
The top LED lights (red).
4. Release button 7.
The transmitter takes approximately 3 seconds to logout. The transmitter
turns off.
1
Check the receiver installation instructions for more details about the logout function in the receiver.
ED-PN-TX103-EN-v04
21
