6. Go to [Erase].
7. Select by pressing the left start button .
8. Select a receiver. Confirm by pressing the left start button. The display shows [Erasing] while the
process is ongoing.
If the erasing fails, the display shows [FAILED]. The transmitter turns off.
If the erasing succeeds, the display shows [OK]. The transmitter turns off.
REPLACE
You can replace a registered transmitter with another transmitter without having access to the receiver.
IMPORTANT! If the transmitter that needs to be replaced is registered in more than one receiver, it will
only be replaced in one receiver at a time. If you want to replace a transmitter in more than one
receiver, you need to perform a replacement for each receiver.
IMPORTANT! Do not perform this when the receiver is in a session with another transmitter. The
radio communication may become disturbed or broken.
NOTE! If the transmitter already have receivers registered, we recommend that you erase all receivers
from the transmitter before starting the replacement. The receiver will automatically be stored in the
same position as it was stored in the old transmitter. If this position is not available, the replacement will
not take place.
Replace a transmitter with a new transmitter
1. Make sure that the stop button is pressed.
2. Pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release the right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
6. Go to [Replace]. Select by pressing the left start button.
7. Enter the serial number/ID code for the transmitter that you want to replace by pressing the buttons
according to the table below:
PRESS BUTTON TO
1
count -1
2
count +1
3
go left
4
go right
-
25
-
Summary of Contents for R00004-05
Page 33: ......