Vis
Alarm Receiver over IP
QUICK INSTALLATION GUIDE
Dm 377-I, Version: 1.0
1. Introduction
This Quick Installation Guide is designed to help the installation process of the Vis and is
geared to quick reference and initial configuration; therefore this document contains information specific to
this aim and does not consider all possibilities. For further information on this please see the
Vis installation manual or contact the Teldat Security technical service.
2. Requirements
Automation software
•
Automation Software compatible with Surgard, Radionics 6500 or Ademco 685 receivers and
an available RS-232 line.
Connections
•
Connection to an Ethernet network (10 or 100 Mbps).
•
Power connection 110-240 V AC.
Configuration
•
PC with serial port (speed 9600, 8 data bits, without parity bits, 1 stop bit and without flow
control) and terminal emulation software (e.g. Windows HyperTerminal).
•
RS serial cable for configuration (DB9 male – DB9 female).
Internet Connection
•
Static and public
1
IP address for the Vis.
1
If Internet access is behind a NAT / firewall, you must have a private static IP address and a UDP port redirected to the said private address.
