TELDAT V
– Installation Manual
I - 14
Doc.DM567-I
Rev.
4.0
To connect the power supply to the device, please follow the steps indicated in the section on
“
To avoid electric shocks, residual current circulation and other unwanted effects, also affecting
communications, the following is recommended:
It is highly recommended that all interconnected communication devices are plugged to THE
SAME GROUNDED POWER OUTLET, which should at the same time be of good quality
(lower than 10 ohms).
Whether the workplace is provided with an uninterrupted power supply system (UPS), regulated
supply or it is independent from the rest (such as lighting, etc.); it is highly recommended that all
data devices should be connected to the same power source. This will avoid operating and
premature aging problems of drivers and other components.
Connecting
•
Make sure that the router’s power supply switch is in the OFF position (0).
•
Ensure that the power supply is NOT connected to either the electricity or the router.
•
Connect all data cables.
•
Connect the power supply cable to the device.
•
Connect the power supply cable to the electricity supply.
•
Put the router’s power supply switch to the ON position (1).
Disconnect
•
Make sure that the router’s power supply switch is in the OFF position (0).
•
Disconnect the power supply from the electricity supply.
•
Disconnect the power supply from the router.
•
Disconnect the data cables.
RST Button
The different features of the RST button are described below.
