Fig. 14:
RST Pushbutton
The user should only operate the pushbutton when it is necessary to ignore the current configuration and establish
the default configuration. This forces start up in either BOOT mode (allowing to update from BOOT), or in BIOS
mode (in order to relicense and delete the configuration files).
1.4.1 Procedure to ignore the current configuration and to establish the default
configuration
These steps should only be carried out when it is necessary to reject the whole configuration of the device (for in-
stance, if you forget the password):
• Turn off the device through the ON/OFF switch.
• Using a sharp object, press the RST pushbutton and hold it down.
• Turn the device on with the ON/OFF switch.
• Wait until the WLAN LED begins to flash (see
on page 10 ) and release the RST pushbutton.
Fig. 15:
Once the WLAN LED is flashing you can release the pushbutton
• Once the pushbutton has been released, the WLAN LED turns off and the process to boot the device with the de-
fault configuration begins.
Note
When the RST pushbutton is released, a message similar to the one shown below will appear on the
configuration console.
CFE version XXXX
Build Date: XXXX
Parallel flash device: name AM29LV320MT, id 0x2201, size 16384KB
CPU type 0x2A010: 300MHz, Bus: 133MHz, Ref: 64MHz
CPU running TP0
Total memory: 67108864 bytes (64MB)
Boot Address 0xbe000000
*** default configuration required ***
Board IP address
: 172.24.251.14:ffff0000
1 Installing the Router
Teldat S.A.
10
Teldat C1+L Router
