Host IP address
: 172.24.75.193
Gateway IP address
:
Run from flash/host (f/h)
: f
Default host run file name
:
Default host flash file name
:
Boot delay (0-9 seconds)
: 3
Boot image (0=latest, 1=previous) : 1
Board Id (0-0)
: 96358C1PL
Number of MAC Addresses (1-32)
: 4
Base MAC Address
: 22:22:22:22:22:22
PSI Size (1-64) KBytes
: 24
Main Thread Number [0|1]
: 0
*** Press any key to stop auto run (3 seconds) ***
Auto run second count down: 0
Booting from only image (0xbe8a0000) ...
Code Address: 0x80010000, Entry Address: 0x80330000
Booting version 10.08.00-00.00
Decompression OK!
Entry at 0x80330000
Closing network.
Closing DMA Channels.
Starting program at 0x80330000
CIT release: XXXXX
Current software license: 22 48
S/N: 706/XXXXX
........
Default configuration used
Parsing text mode configuration ...
Configuration parsed
Initializing
Press any key to get started
This process does not automatically delete the previously stored configuration. The latter is just ignored and the de-
fault configuration appears in its place.
1.4.2 Procedure to force start up in BOOT mode
This procedure is applied if you need to force the device to start up in BOOT mode in order to load/upgrade the C.I.T.
image from BOOT. For further information on how to do this in BOOT mode, please see the manual on software up-
grading (Dm748-I).
The procedure to force start up in BOOT mode is as follows:
• Turn off the device through the ON/OFF switch.
• Using a sharp object, press the RST pushbutton and hold it down.
• Turn on the device with the ON/OFF switch.
• Wait until the WLAN LED begins to flash (see
on page 11 ). Keep the RST pushbutton held down.
Fig. 16:
The WLAN LED flashes
Teldat S.A.
1 Installing the Router
Teldat C1+L Router
11
