1.2.1 Power Source Connection
Some of the Teldat C+ models are powered with an external AC/DC source.
To avoid electric shocks, residual current circulation and any other unwanted effects that may disrupt communica-
tion, the following is recommended:
Warning
All interconnected communication devices should be plugged to THE SAME GROUNDED POWER
OUTLET, which should, at the same time, be of good quality (lower than 10 ohms).
Whether the workplace is provided with an uninterrupted power supply system (UPS), regulated supply,
or it is independent from the rest (such as lighting, etc.), it is highly recommended that all data devices
should be connected to the same power source. This will avoid operating and premature aging prob-
lems of drivers and other components.
1.2.1.1 Devices with external power supply
Fig. 4: Teldat C8+ power connection with an external source
Fig. 5: Teldat C9+ power connection with an external source
To connect the power source to the device, follow the steps listed in the previous table: ensure the switch is OFF (0)
and the power supply is NOT connected to the main electricity supply; find the POWER plug (located on the rear
panel of the device) and plug it into the power source. Both the connector and the receptacle are designed to ensure
their proper installation.
For subsequent power source connections to the main electricity supply, use the grounded cable provided for this
purpose.
1.2.1.2 Devices with internal power supply sources
To connect the power source to the device, check that the power switch is in the OFF position (0) and the device is
NOT connected to the mains, find the power connector (located on the rear of the device) and plug it into the groun-
ded power cable (the shape of the connector prevents incorrect insertion).
1 Installing the Router
Teldat S.A.
4
Teldat C+ Router Family
