Rev.001
ICE S 2800
15
- Fan = ventilation only mode
The third field (Fig. 20 ref. 3) shows fan
mode.
The two figures in the first field (Fig. 20 ref. 1)
normally indicate the ambient temperature
detected by the air conditioner inside the
camper.
When setting the desired temperature with
the remote control, the two digits show the
set temperature for about 15 seconds; they
then show the temperature in the camper
interior again.
5.9 Setting system time on remote
control
After inserting the batteries, set the system
time on your remote control:
1) Press and hold down the
SET
key on
your remote control until the system time
digits start flashing
2) By using the
+HOUR
and
–
HOUR
keys,
set your system time
3) Press the
SET
key once again
5.10 Automatic operation mode
1) Press the
On/Off
key
2) Press the
MODE
key repeatedly until the
display shows the
Automatic
mode
symbol
3) Set your required temperature with the
keys
+TEMP
and
–
TEMP
4) Press the
FAN
key several times until you
reach your required ventilation setting.
5.11 Cold operation mode
1) Press the
On/Off
key
2) Press the
MODE
key repeatedly until the
display shows the
COLD
mode symbol.
3) Set your required temperature with the
keys
+TEMP
and
-TEMP
.
4) Press the
FAN
key several times until you
reach your required ventilation setting.
5.12 Heating operation mode
1) Press the
On/Off
key
2) Press the
MODE
key several times until
the display shows the
HOT
mode symbol.
3) Set your required temperature with the
keys
+TEMP
and
-TEMP
.
4) Press the
FAN
key several times until you
reach your required ventilation setting.
5.13 Ventilation operation mode
1) Press the
On/Off
key
2) Press the
MODE
key several times until
the display shows the
VENTILATION
mode symbol.
3) Press the
FAN
key several times until you
reach your required ventilation setting.
If the air conditioner is switched off
and
immediately
re-started
or
the
operating mode is changed, a three-
minute interval will elapse before the
compressor resumes operating.
If the air conditioner is turned off
during the heating mode, the fan will
remain in operation for a few minutes in
order to dissipate the heat accumulated
inside the air conditioner, before stopping
automatically.
In cooling mode, the external
condensing
fan
speed
changes
automatically depending on the required
performance
and
the
environmental
temperature.
5.14 Timer setting
1) Press the
TIMER
key on the remote
control: the start time
ON
indicator is
activated
2) By using the
+HOUR
and
–
HOUR
keys,
set the start time
3) Press the
TIMER
key once again: the
stop time
OFF
indicator is activated
Summary of Contents for ice S2800
