Telair ice S2800, Manual For Installation And User Manual

Page: 10 / 28

ICE S 2800 Rev.001
10
4.3 Positioning the air conditioner
Before installation, check that the
cylindrical section seal on the air
conditioner
base is still correctly
positioned inside its special frame seat
(Fig. 7 ref. 1).
In case of a rough or uneven roof surface,
coat the opening perimeter area on which the
seal provided on the bottom of the
conditioner must be applied with a thin layer
of soft sealant or a bituminous strip. Apply the
recommended amount of product. If an
excessive amount is applied, the bottom of
the air conditioner might be glued to the roof
of the vehicle, cancelling the damping effect
of the seal, with the resulting propagation of
noise and vibrations. This would also make it
harder to remove the air conditioner, when
needed, with the risk of causing damage to
the roof.
Bring the air conditioner onto the roof (fig. 7
ref. 2) and,
without scraping it , position it
over the 360 x 360 mm opening previously
lined with sealant. Correct alignment of the
air conditioner on the roof will provide a view
- from inside the camper - of the 4 threaded
fixing seats.
The arrow in fig. 7 indicates direction of
forward drive.
Working from inside the vehicle, shift the air
conditioner until the four fixing threads are
aligned with the square 360 x 360 mm
opening of the hole on the roof.
Ensure that the cylindrical seal at the bottom
of the air conditioner is again correctly
installed in its seat.
4.4 Connecting the power lead
Connect the previously prepared cable of the
unit to the 230V AC power supply terminal
(Fig. 9).
Please note that the colour of the wires
according to their use is:
blue wire: neutral
brown wire: phase
yellow-green wire: earth
Check that the power lead is not excessively
long as it could obstruct the intake grilles.