www.tekvox.com
TPHD2-WP1
79066 User Manual
No. Name
Description
7
LINK & HDCP
Indicators
LINK: Lights up green when HDBaseT is properly connected
HDCP: Lights up green when the source signal contains HDCP
information, blinks when HDCP is not present, and turns off when there is
no source signal
8
Reset
Press to reboot the TPHD2-WP1
9
Firmware
USB port used for updating firmware. To update firmware, plug in flash
drive with “MERGE.bin”
update file, then send command 40698%
1.2.2 Side Panel Description
No. Name
Description
1
HDBaseT Output
Connect to HDBaseT receiver via CAT cable to deliver audio/visual
signals with support for PoH (Power over HDBaseT) from receiver.
Note:
The TPHD2-WP1 supports unidirectional PoH, and cannot be
used to power far-end receiver.
1.2.3 Rear Panel Description
No. Name
Description
1
Power In
Connect to DC 12V power adapter if not being powered by receiver
2
Power Out
Supplies DC 12V power for TekTouchPad (if used)
3
RS232
Bi-directional RS232 port for connection to TekTouchPad. This port can
be used to control the TPHD2-WP1, or to control a remote device
connected to the receiver.
