2
Installation
Version 1 TekKeypad
First remove the keypad, power supply and RS232 control cable to TEK 902. The only wires used are the IR /
Login In 3 and GND. Connect the IR wire to the Tip and the GND to the Sleeve of the supplied 3.5mm plug. If
the Podium Equipment Security cable is used, you will need to connect the end of the loop to ground. This can
be done on the GND sleeve connection.
Version 2 TekKeypad
First remove the keypad, Cat 5 cable, power supply, 3.5mm male phono connector, white connector plate / gray
box and RS232 control cable to TEK902. If the red Podium Equipment Security cable is wired to the inside of the
connector plate, you will need to connect it to ground wire of the 3.5 mm plug. This can be done on the GND
sleeve connection of the 3.5 mm plug.
TekTouchPad
1. Mount the TekTouchpad subbase to the wedge. Use the two supplied 4/40 mounting screws to secure it.
2. Connect the 80014 RJ-12 cable to the back of the TekTouchPad and make certain you leave enough slack to
remove the TekTouchPad once it is installed.
3. Plug the 3.5mm male phono connector in to the 3.5mm Female 80014 cable.
4. Carefully press the TekTouchPad on to the Subbase, without pressing on the glass, until it is firmly inserted.
5. Connect the DB-9 male directly to the TEK 1201
’s supplied RS-232.
6. Connect the supplied 12 volt power supply power cable to the 80014 female 2.1 mm power cable.
If touchscreen needs calibration, power-cycle the unit while pressing center of screen. It is best to use a stylist or
something like a small eraser to set calibration points.
Wedge is not included.
Summary of Contents for TekTouchPad
Page 4: ...4...