Enter the password “88888”, and then you can enter the configuration page to configure the IP
port, including the IP reset, PW reset etc.
Notice:
Serial configuration cannot be changed.
After configuration, reset device, then you can use the new IP address for controlling.
10.2 Connection and Control
To send IP commands to the TEK 1201-HD connect using TCP/IP port 4001 and the set IP
address of the unit. Use the standard serial commands from a control system or program that can
send a complete command line. You cannot type the command using a Telnet program.
11. Firmware Updating
The TEK 1201-HD supports firmware field-updating, by USB flash disk.
1: Copy the file “MT23ATV.bin” to a USB flash disk.
2: Plug the USB flash disk to the USB port on the unit.
3: Pressing the button “HDMI” on the front panel for 6 seconds or sending RS232 command 0698%
for updating, then press the button “OK” on the remote or send RS232 command 0609% to
confirm update. The unit will capture the new firmware from USB flash disk.
4:
After updating is completed, reboot and send the command “
0617%
” to reset to factory settings.
This command must be sent using a command line program set to 115200.
5: After reset, reboot again.
Notice:
The name of the update file must be
MT23ATV.bin
.
