Line Select
The Line Select function allows you to select which video line to view in the
Waveform, Vector, Lightning, Arrowhead, Diamond, Split Diamond, Bowtie,
and Datalist displays.
NOTE.
In the Picture display, the selected video line is highlighted in the picture
image when the Picture Line Select Cursor is enabled in the CONFIG >
Graticules & Readouts submenu.
In full screen mode, when you enable Line Select and select a video line in one
display (for example, the Waveform display), if you then select another
applicable display type using the display-mode buttons (for example, the
VECTOR button), the new display will automatically view the same video line. If
you select another display mode using the DISPLAY SELECT button, you will
have to enable Line Select for that display mode to view the same video line.
In 4-tile mode, you must enable Line Select for each applicable display type.
When enabled, each applicable display type will show the same video line. If the
Waveform display is set to field sweep and it is one of the display modes in a 4-
tile display, the selected video line is highlighted in the field sweep when the
Field Sweep Line Select Cursor is enabled in the CONFIG > Graticules &
Readouts submenu.
Perform the following steps to select a video line to view:
1.
Select the tile containing the display for which you want to enable Line
Select.
NOTE.
Line Select mode can only be active on one tile at a time, but the line
select brightup cursor does appear in other tiles and moves as you select
lines in the active tile.
2.
Press the
LINE SEL
button to toggle Line Select on or off. When on, the tile
displays the selected line information only.
3.
Press the left or right arrow key to select
F1
(field 1),
F2
(field 2), or
All
. See
also
Figure 53: Navigating line selection
on page 160.
NOTE.
For dual link signals in fast progressive video formats, use the arrow
keys to select fields. In the Datalist display, press the button to toggle
between Line Select and Sample Select.
4.
The line and field information will appear at the bottom of the display screen.
5.
Use the General knob or the up/down arrow keys to select a video line to
view.
Functions
WFM2300 and WFM2200A Waveform Monitors User Manual
159
Summary of Contents for WFM2200A
