Tutorial
1Ć12
Example 3: Automated Measurements
In this example you learn how to use the automated measurement system to
get numeric readouts of important waveform characteristics.
The signal display must be stable to use the automated measurement sys-
tem. Also, the waveform must have all the segments necessary for the mea-
surement you want. For example, a rise time measurement requires at least
one rising edge, and a frequency measurement needs at least one complete
cycle.
1.
If you are not continuing from the previous example, follow the instruc-
tions on page 1-1 under the heading “Setting Up for the Examples.”
2.
Press SETUP
➞
Recall Factory Setup (main)
➞
OK Confirm Factory
Init (side).
3.
Press AUTOSET.
4.
Press MEASURE to display the Measure main menu (see Figure 1-14).
Figure 1-14: Measure Main Menu and Select Measurement Side Menu
Displaying
Automated
Measurements
Summary of Contents for TDS 620
