Installation
DC reject button
Press the DC Reject button to eliminate the DC
component of the measured signal from the
output of the probe. The LED lights to indicate
that the DC Reject is enabled.
DC reject is useful when you are measuring
small amplitude signals superimposed on a
large differential offset component. DC reject
generates an internal offset that cancels the
DC component of the signal.
Because the input is always directly coupled,
the DC reject mode does not increase the
common and differential mode dynamic ranges
for DC components. The DC reject mode
also disables any capability of external offset
adjustment.
Press the button again to disable DC Reject
and return to DC coupling.
TDP0500 & TDP1000 Quick Start User Manual
7
