Installation
Degaussing the Probes
1.
After the TCP0020 probe is connected
to the oscilloscope, the multicolor
Degauss/AutoZero
status LED
fl
ashes
red to indicate a degauss is required.
The oscilloscope screen display may also
prompt you to degauss the probe.
The TCP2020 probe does not indicate
that a degauss is needed, but you should
always degauss a current probe after
connecting it to the oscilloscope.
2.
To degauss the probe,
fi
rst verify that the
Jaw Open
LED is not lit. If it is lit, push the
probe slider forward to lock the jaw closed.
20 A Current Probes Instruction Manual
5