Tektronix RSA6100A Series, Help Manual

Page: 216 / 415

RF Measurements > Common Controls for RF
Measurements Displays Prefs Tab
Prefs Tab
The Prefs tab enables you to change parameters of the measurement display. The parameters available on
the Prefs tab vary depending on the selected display, but include such items as enabling/disabling Marker
Readout, switching the Graticule display on/off, and Marker Noise mode. Some parameters appear with
most displays while others appear with only one display.
Setting Description
Show graticule Shows or hides the graticule.
Show Marker readout in graph
(selected marker) Shows or hides the readout for the selected marker in the graph area.
Max trace points In general, time-domain traces can include up to 100K points and frequency-domain
traces can include up to 10K points. When the analysis produces a results array longer
than the selected trace length, the trace is decimated (using the method speci
fi ed with
the Detection control) to be equal to or less than the Max trace points setting (except
when Max trace points is set to Never Decimate). This decimated (or undecimated) trace
is what is used for marker measurements and for results export.
Settling Time decimal places
(Frequency and Phase Settling
Time displays only) Speci fi es the number of decimal places shown in the results readout below the graph.
This setting does not affect the precision of internal calculations.
Show trace legend (Phase
Noise display only)
Displays or hides the trace legend.
xxx
204
RSA6100A Series Real-Time Spectrum Analyzers Help