Tektronix RSA6100A Series, Help Manual

Page: 202 / 415

RF Measurements > Common Controls for Settling Time
Displays Settling Time Displays Shared Measurement
Settings
Settling Time Displays Shared Measurement Settings
The control panel tabs in this section are shared by the Frequency and Phase Settling Time displays. These
control panel tabs are not shared with other RF Measurement displays. With few exceptions, each display
shares values for each of the controls on these tabs. For example, Vertical Scale values are independent for
each of the displays (degrees for Phase Settling Time and Hertz for Frequency Settling Time).
Common controls for settling time measurement displays
Settings tab Description
De fi ne (see page 190) Speci fi es the parameters that characterize the settling time measurement.
Time Params (see page 192) Speci fi es the Measurement length and minimum settled duration for the settling time
measurement.
Mask (see page 193) Speci fi es the parameters used for Mask testing.
Trace (see page 193) Specify which traces to show and how they are computed.
Scale (see page 196) Speci fi es the vertical and horizontal scale settings.
Prefs (see page 197) Speci fi es display parameters of the Settling Time displays.
xxx
De fi ne Tab for Settling Time Displays
The De fi ne tab for the Frequency Settling Time measurement controls several parameters that affect
how the measurement is made.
Meas Freq
Select the frequency of the signal to be measured. Measurement Frequency can be selected as the target
frequency (see
Target Reference ).
NOTE. If Lock Center Frequency of Spectrum Display to Measurement Frequency is unchecked, then
Measurement Frequency is independent of Center Frequency) Range: Entire input frequency of the
instrument
190
RSA6100A Series Real-Time Spectrum Analyzers Help