Pulse Pro
fi
ling Application
8.
Observe that the measurement result does not change as long as an entire
pulse is selected. That is, if you move the left gate closer to the left edge of
the display, the measurement result remains unchanged.
Figure 5: Position of gates for measurement
9.
Observe that the drop down menu on each gate shows the selection of
measurements that can be made. You can also right-click on the gate in
the Results window. A dashed line (–.–) will appear if the gate cannot take
a measurement or is not set.
You can compare a manual measurement like the one just explained with an
automatic measurement by doing the following:
1.
Check that there are at least two pulse cycles in the Measurement window.
2.
Click on the Auto Measure tab to view the Auto Measure window.
3.
Click Start Measurement.
4.
Compare the results.
RF and Microwave Power Sensors/Meters
51
Summary of Contents for PSM3000 Series
