1-2. Using an Ethernet Connection
PER-PRT-0004
1-2
9/98
Westinghouse Proprietary Class 2C
1-2. Using an Ethernet Connection
This section describes how to connect and configure a network Phaser 350 printer.
1-2.1. Connecting the Printer
Use the following procedure to connect the Phaser 350 printer to a network.
Confirm Ethernet Hardware
1. Optional Ethernet internal hardware (a PhaserShare card) must be installed
in the Phaser 350 printer before it can be used on an Ethernet. If a PhaserShare
card is installed in the printer, the interface shown in Figure 1-1 will be visible
on the back of your printer.
2. If there is no PhaserShare card installed, and you want to use an Ethernet
connection, contact your Westinghouse representative. Purchase the Ethernet
hardware and install it in the Phaser 350 printer. After the required hardware is
installed, proceed to Step 3.
3. Make sure you use an appropriate Ethernet cable (based on the Ethernet card
used in your printer as shown in Figure 1-1) to connect the printer to the
network.
4. Confirm that the two dip switches (Switch 1 - Service; and Switch 2 - Reset) in
the back of the printer are in the Up position.
Leave the Service switch in the Up position.
The Reset switch can be used to reset the printer. To reset the printer, put switch
2 in the Off (down) position and then turn it back to the On (up) position.
Figure 1-1. PhaserShare Card Interfaces
TX
PhaserShare
TM
Ethernet Card
