Remote access from a Web browser
You can remotely access your network-connected instrument from a Web browser to display the instrument user interface on a
PC.
This procedure describes how to remotely access the UI controls and screen for the instrument.
Prerequisites:
■
on page 34
■
Determine the IP address of the oscilloscope that you want to access. To determine the oscilloscope's IP address, select
Utility > IO in the oscilloscope menu bar and view the network settings in the LAN panel.
1. Open a Web browser on a PC connected to the same network as the oscilloscope.
2. Enter just the oscilloscope IP address on the URL line of the browser and press Enter. For example: 135.62.88.157. The
browser searches for and opens the Web page for the oscilloscope.
Connect the oscilloscope to a PC using a USB cable
Use a USB cable to connect the oscilloscope directly to a PC for remote instrument control.
1. On the oscilloscope, select Utility > I/O from the menu bar.
2. Tap USB Device Port.
3. Confirm that the USB Device Port control is On (default setting).
4. Connect a USB cable from the PC to the USB Device port on the rear of the instrument.
5. If using the USB connection to remotely control the oscilloscope using GPIB commands, set the GPIB Talk/Listen Address
for your configuration (0 - 30).
Cleaning
Use a dry, soft cotton cloth to clean the outside of the unit. If any dirt remains, use a cloth or swab dipped in a 75% isopropyl
alcohol solution. Use a swab to clean narrow spaces around controls and connectors. Do not use any liquid cleaning agents or
chemicals that could damage the touchscreen, case, controls, markings or labels, or possibly infiltrate the case.
Installing your instrument
MDO32, MDO34 Installation and Safety Manual
7
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
