Tektronix Keithley SourceMeter 2470, Reference Manual

Page: 969 / 995

2470 High Voltage SourceMeter Instrument Reference Manual Appendix B: Status model
2470-901-01 Rev. A /
May
2019 B-7
Operation Event Register
You can program the bits in the Operation Condition and Operation Event Status Registers to be
cleared or set when an event occurs.
When an enabled Operation Event Register bit is set (because the enabled event occurs), the
corresponding bit B7 (OSB) of the Status Byte Register is set. The corresponding Operation Event
Register Condition Register reflects the present status of the instrument, so it will be set while the
event occurs.
You can use the following commands to read and set bits in the Operation Event Register.
Description SCPI command TSP command
Read the Operation
Condition Register :STATus:OPERation:CONDition? (on
page 12-97)
status.operation.condition (on page
14-181)
Set or read the contents of
the Operation Event Enable
Register :STATus:OPERation:ENABle (on page
12-97)
status.operation.enable (on page
14-181)
Read the Operation Event
Register :STATus:OPERation[:EVENt]? (on page
12-98)
status.operation.event (on page
14-182)
Request the mapped set
event and mapped clear
event status for a bit in the
Operation Event Registers :STATus:OPERation:MAP (on page
12-99)
status.operation.getmap() (on page
14-183)
Map events to bit in the
Operation Event Register :STATus:OPERation:MAP (on page
12-99)
status.operation.setmap() (on page
14-183)
The instrument returns a decimal value that corresponds to the binary-weighted sum of all bits set in
the register. See
Event numbers (on page B-9) for information about event numbers. You can use a
copy of the following table to record settings for your instrument.
Bit
Decimal
value Set Event Clear Event When set, indicates the following
has occurred:
0 1
1 2
2 4
3 8
4 16
5 32
6 64
7 128
8 256
9 512
10 1024
11 2048
12 4096
13 8192
14 16 384