Section 14: TSP command reference
2470 High Voltage SourceMeter Instrument Reference Manual
14-182
2470-901-01 Rev. A /
May
2019
Example
-- decimal 20480 = binary 0101 0000 0000 0000
operationRegister = 20480
status.operation.enable = operationRegister
Sets the 12 and 14 bits of the operation
status enable register using a decimal
value.
Also see
(on page B-7)
(on page B-15)
status.operation.event
This attribute reads the Operation Event Register of the status model.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (R)
Yes
Not applicable
Not applicable
Not applicable
Usage
operationRegister
= status.operation.event
operationRegister
The status of the operation status register
Details
This attribute reads the operation event register of the status model.
The instrument returns a decimal value that corresponds to the binary-weighted sum of all bits set in
the register.
Example
status.request_enable = status.OSB
status.operation.setmap(0, 4918, 4917)
status.operation.enable = 1
defbuffer1.clear()
defbuffer1.fillmode = buffer.FILL_ONCE
defbuffer1.capacity = 10
smu.measure.count = 10
smu.measure.read()
print(status.operation.event)
Set bits in the Status Request Enable Register to record an enabled event in the Operation Status Register.
Map event number 4918 (buffer full) to set bit 0 in the Operation Event Register and event number 4917 (buffer
empty) to clear bit 0.
Clear
defbuffer1
.
Set
defbuffer1
to fill once.
Resizes
defbuffer1
to 10 readings.
Sets the measure count to 10 readings and makes a measurement.
Reads the operation event register.
Output:
1
Also see
(on page B-7)
